Factory reset

You can perform a factory reset by pressing the button inside the S32 and E32 Gateway for 10 seconds. If you have a Premium II with the latest firmware 2.2.2b0 you can use a metal pin to shortcut pins D3 to D2 on the Wemos for 10 seconds.

If the above methods do not work, you have to upload the firmware again. See: HERE.

Where can I find the button?

Gateway S32

There is a small button right next to the USB connector called ‘IO0’. If you press it for 10 seconds, you device will restart and reset all settings to factory default.

EMS Bus Gateway S32 reset button

Gateway E32

There is a button on the board called ‘reset’ or ‘button’. If you press it for 10 seconds, you device will restart and reset all settings to factory default.

EMS Bus Gateway E32 reset button

Gateway Premium II and older

The Gateway Premium does not have a reset button. Although there is a button on the Wemos called ‘reset’, it’s actually just a reboot button. Pressing it will only restart the Wemos, it does not reset anything.

If you are on firmware 2.2.2b0 you can use a metal pin to shortcut pins D3 to D2 on the Wemos for 10 seconds to reset EMS-ESP.