31 March 2020: I am still able to ship products normally and there is enough in stock.
If at some point during the next few weeks orders cannot be shipped in time anymore due to corona troubles you can either wait or cancel the order for a full refund.

This store is dedicated to products for integrating your boiler, heatpump, thermostat, solar or mixer module from a Bosch brand like Bosch, Nefit, Buderus, Junkers, Sieger or Worcester into your home automation system like Domoticz or Home Assistant.
You can read out every parameter and f.i. set the temperature directly from your home automation system.
I accept almost all major payment options and I ship to most countries.

Almost all Bosch brand boilers use the same EMS interface bus interface to connect thermostats, solar/mixer modules to the boiler/heat pump.
Depending on the brand and the protocol version, the bus is called EMS, EMS+, EMS2, ‘2-wire bus’ and Heatronic 3.

EMS Bus Wi-Fi Gateway

The EMS Bus Gateway is a complete plug and play set neatly packed in a small enclosure that fits into your hand. Just plug in the device to the service jack on the boiler with the supplied jack cable and stick it to the side of the boiler (its magnetic). No additional cables are needed and everything is powered from the service jack itself.
The Premium II can also be powered from the EMS bus itself just like a thermostat.
All Gateways connect via Wi-Fi to your home network.

EMS to TTL interface board

I also offer a more simple EMS bus to TTL interface board which can interface the EMS bus with an Arduino, ESP8266, Raspberry Pi etc. Sold all over Europe and beyond, this is the tried and tested method to play with the EMS bus that works for basically everyone.
A modified version is now also available so you can interface with older iRT based boilers like the Nefit Ecomline.

See below for all products.

Products